company

Specification

Home > Product > Specification

3 Stations

4 Stations

3 Stations

comparison

▪ 3 Stations iB

ITEM / MODEL

Screw diameter	mm	40	40	50	50	60	65	76	65	76
Injection volume	cm³/shot	169	169	264	333	480	580	770	580	770
Injection stroke	mm	140	140	140	180	180	180	180	180	180
Plasticizing rate	cm³/s	18	18	30	30	50	60	75	60	75
Screw L/D ratio		22	22		22		22		22
Preform clamp	kN	386	580		720		1200		1600
Blow mold clamp	kN	58	130		160		260		300
Press stroke	mm	120	130		140		152		152
Max. Die. set	mm	470×350	620×400		700×400		1000×500		1200x600
Trigger bar	mm	360	475		600		920		1220
Dry cycle time	sec	3	3		3		3.5		3.5
Oil tank capacity	ℓ	160	160		160		250		250
Air Consumption	ℓ/min	280	500		700		900		1100
Power supply	kW	32	40		40		53		65
L × W × H	m	3.8×1.5×2.3	4×1.7×2.3		4.5×2×2.6		5×2.4×2.7		6x2.6x2.7
Total Weight	ton	4.7	7		8.5		12		14

▪ 4 Stations iB4

ITEM / MODEL

Screw diameter	mm	30	45	50
Injection volume	cm³/shot	95	215	264
Injection stroke	mm	135	140	140
Plasticizing rate	cm³/s	6	24	30
Screw L/D ratio		22	22	22
Preform clamp	kN	200	480	720
Blow mold clamp	kN	65	130	220
Press stroke	mm	130	145	180
Max. Die. set	mm	270 x 400	520 x 350	700 x 400
Trigger bar	mm	130	360	550
Dry cycle time	sec	3	3	3
Oil tank capacity	ℓ	65	160	160
Low compressed air	bar	6~10	6~10	6~10
High compressed air	bar	20~40	20~40	20~40
Air consumption	ℓ/min	300	500	700
Power supply	kW	18	39	45
Max. Length	m	2.1	4.4	4.6
Max. Width	m	1.2	1.8	2
Max. Height	m	2.1	2.5	2.8
Total Weight	ton	3.5	7	10

▪ 3 stations iSB

ITEM / MODEL

Screw diameter	mm	45	60
Injection volume	cm³/shot	215	495
Injection stroke	mm	140	175
Plasticizing rate	cm³/s	24	50
Screw L/D ratio		22	22
Preform clamping	kN	230	540
Preform press stroke	mm	600	600
Blow mold clamping	kN	200	300
Blow press stroke	mm	130	150
Lip mold MAX. Center	mm	250	385
Low compressed air	bar	6~10	6~10
High compressed air	bar	20~35	20~35
Servo pump motor	kW	32.5	43
Heater	kW	8.2	16
L × W × H	m	4.2x1.4x3.1	4.8x1.8x3.2
Total Weight	ton	7	10